A Ann Arbor resource for epoxy flooring done right.

The coating system that actually holds up across an Ann Arbor winter runs four passes: a primer sized to the slab's vapor reading, a solids epoxy base for the structural bond, a full vinyl chip broadcast for grip and depth, and a polyaspartic topcoat for hardness and daylight stability. Reputable installers run that stack. The failure points (single-layer water-based kits from the home center, skipping the moisture primer, handing residential installs to part-time subs) are why most failed floors in this region failed inside two winters.

Three buyer profiles tend to land on a Ann Arbor epoxy search. The Burns Park or Old West Side homeowner wanting a garage or basement floor that finally lasts past one summer. The Stadium Boulevard shop owner who needs a forklift-rated floor installed over a weekend so the operation never closes. The general contractor who needs a coating partner reliable enough to hand a slab to and walk off. The install process is the same in each case. Only the material volume and the cure-window phasing change.

A quote request submitted through the form routes to a local installer who calls back inside one business day. Most residential walk-throughs land inside the same week. If a damaged epoxy floor is already on the slab, the installer runs the one-foot diagnostic test grind during the visit and quotes a repair-and-recoat side-by-side against a full tear-out so the two numbers can be compared honestly.